Table &1 does not fit into window.

What causes this issue?

You tried to display table &V1& in a window. However, the table either
is too wide for the window or a horizontal shift by the specified value
is impossible because the table would then no longer fit into the
window. The same error occurs if a template is too high for the current
subwindow. This is usually noticed in the check when the form is
activated, but in some cases (with device types such as ASCIIPRI) the
table measurements have to be adapted and this does not occur until
runtime. With device type ASCIIPRI, for example, only integral
multiples of 1/6 inches (vertical) or 1/10 inches (horizontal) can be
used for positioning. The height of a line within a template therefore
changes, for example, from 3mm to 4.2mm, causing the total height of
the template to increase and exceed the height of the window.

System Response

The system issues an error message.

How to fix this error?

Correct the positioning of table &V1& or make the window bigger.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.