Total = &1%, &3, period &2, source assignment &4
Message type: E = Error
Message class: KD - CO Settlement
Message number: 041
Message text: Total = &1%, &3, period &2, source assignment &4
What causes this issue?
You entered distribution rules which settle &V1&% in total. This
applies to view/version/settlement type &V3& and source assignment &V4&
in period &V2&.
When checking the percentage total, the system found one of the
following errors:
The total percentage for the distribution rules is greater than 100%
The total percentage for the distribution rules is less than 100% and
this is a rule for full settlement (settlement type FUL).
The total percentage for the distribution rules is less than 100% and
the 100% check is switched on in the settlement profile.
If you are using a source structure and source assignment " ", note the
following:
The system issues an error message and will not allow you to continue with this transaction until the error is resolved.
Source assignment " " is assigned to all possible origin assignments inthe structure you are using. This is even if you did not specifically
use the corresponding source assignment.
Example:
Source assignments (SA) A and B are defined in your structure. You
specified two rules:
SA ' ' 70%
SA 'A' 30%
The system outputs an error message for OA "B" because this only
displays 70% (from SA " ").
How to fix this error?
If you are settling using fixed amounts you can ignore this message.
The settlement then checks whether the settlement sender is fully
credited.
Otherwise, correct the percentages for settlement type &V3& and source
assignment &V4&, so that you are settling exactly 100% in period &V2&.
If you do not have full settlement rules, you can switch off the 100%
check in the settlement profile. This procedure also suppresses the
message in future.
<ZH>Note</>
If you cannot find any fields where you can enter percentage values,
this is probably because the settlement profile is configured to hide
them. Switch on percentage settlement in the settlement profile.
Alternatively you can use equivalence numbers for your rules, if the
project profile allows this.
Error message extract from SAP system. Copyright SAP SE.
